Type ethernet into the windows search bar and head to change adapter options

[+] Right click on your active network and click Properties. Follow the settings below:

Client for Microsoft Networks / Disabled File and Printer Sharing for Microsoft Networks / Disabled QoS Packet Scheduler / Enabled Internet Protocol Version 4 (TCP/IPv4) / Enabled Microsoft Networks Adapter Multiplexor Protocol / Disabled Microsoft LLDP Protocol Diver / Disabled Internet Protocol Version 6 (TCP/IPv6) / Disabled Link-Layer Topology Discovery Responder / Disabled Link-Layer Topology Discovery Mapper I/O Driver / Disabled

[+] After disabling these settings, head over to the Configure tab and go to Advanced. You might not see all of these options, do only what you have.

Advanced EEE / Disabled Network Address / Not Present - MAKE SURE! ARP Offload / Disabled Flow Control / Disabled IPv4 Checksum Offload / Disabled Large Send Offload v2 (IPv6) / Disabled TCP Checksum Offload (IPv6) / Disabled UDP Checksum Offload (IPv6) / Disabled

[+] Open cmd, and type those commands in delay of 30s between each other.

ipconfig /flushdns ipconfig /registerdns ipconfig /release ipconfig /renew netsh winsock reset

[+] Open cmd again as admin and run (Delay of 5s between each)

arp -d netsh interface IP delete arpcache